Xpress XEB09-C Bedienungsanleitung PDF herunterladen (Seite 1)

XPressEthernetBridge

™

Product Manual - Commercial/Indoor XEB09-C

Create long range wireless links in minutes!

Connect any Ethernet device to the XPress Ethernet Bridge

RF Modems and the bridge will function in place of

an Ethernet cable. The Ethernet bridge provides a

transparent wireless point-to-point cable replacement.

www.maxstream.net

Introduction

This manual provides step-by-step instruction on how to setup a wireless link and test the

Ethernet Bridge’s ability to transport data over varying ranges and conditions.

Included with the XPress Ethernet Bridge (Commercial)

(2) XPress Ethernet Bridge RF Modems

(2) 6 VDC/80-240 VAC power adapters (not included w/ version XEB09-C-AU (Australia))

(2) Half-wave, 2.5 dBi, dipole antennas w/RPTNC connector

Quick Setup

Hardware Setup

Each RF Modem automatically selects the best radio channel, encrypts the Ethernet traffic and

transports the data wirelessly to its matched pair. Cross-over cables are not necessary since the

RF modems automatically sense the device (client vs. switch).

Figure1. EthernetBridgeSetup

1. Plug both RF Modems into power outlets using the included power adaptors.

(If operating in Australia: Use power adapters that meet Australian regulations and the

supply voltage specifications cited on page 4 this manual.)

2. Connect an Ethernet cable from each XPress RF Modem to a network device.

3. Send Ethernet traffic through the wireless Ethernet Bridge [for troubleshooting, refer to

the following page].

1 2 3 4

Inhaltsverzeichnis

Seite 1 - XPressEthernetBridge

XPressEthernetBridge™Product Manual - Commercial/Indoor XEB09-CCreate long range wireless links in minutes!Connect any Ethernet device to the XPress

Seite 2 - Troubleshooting

LED DisplayThe XPress RF Modem has 16 LEDs that display the status of the device.TroubleshootingNo Power LED:Check the power connections.No Radio Link

Seite 3 - Advanced Settings

Advanced SettingsAutomatic Frequency Selection Mode (All DIP Switches OFF (up))<Default Configuration> The RF modem is designed to automatically

Seite 4 - Contact MaxStream

Technical SpecificationsFCC ComplianceContact MaxStreamPhone: (801) 765-9885OnLine Chat: www.maxstream.nete-mail: [email protected]

Kommentare zu diesen Handbüchern

Keine Kommentare

Xpress XEB09-C Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Modems Xpress XEB09-C herunter. Xpress XEB09-C User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern